Load Media Roll

Printing Setup Software – VersaWorks

File Format Supported (Recommand)

JPG

Recommended Dimension: Low, Medium, Large

Poster/Banner Printing

PDF

Dimension: Low, Medium, Large, Vector file

Poster/Banner/Sticker Printing and Cutting

TIFF

Recommended Dimension: Large, Extra-Large

Poster/Banner Printing

VersaWorks Basic Function

Import File

1.

2.

NEST

1.

2.

Settings

1.

2.

Layout

1.

2.

Quality

1.

2.

Test Cut

For high-quality cutting, we recommend carrying out a cutting test to check the cutting quality for the media before you perform actual cutting. Adjust the blade force depending on the cutting quality.

  1. Press [FUNCTION].
  2. Press [▼] several times to display the screen shown below.
  3. Press [▶] to display the screen shown below.
  4. Press [ENTER].
    The test pattern is cut.
  5. Press [▼] to display the screen shown below.
  6. Press [▶] to display the screen shown below.
  7. Peel off the cut shapes to verify the cutting quality.
  8. Two shapes are peeled off separately
    You do not need to perform the setting because the blade force is appropriate.
    • Two shapes are peeled off together/backing paper is also cut
    Proceed to the next step to set the blade force.
  9. Press [▲] or [▼] to select a value.
    • Two shapes are peeled off together
    Raise the blade force.
    • Backing paper is also cut
    Reduce the blade force.
  10. Press [ENTER] to confirm your entry.
  11. Re-do TEST CUT process.
  12. Check whether the correction was successful.
    Press [MENU] to finish the test cut.
  13. At the [CUT CONFIG] menu, you can also make settings for other cutting conditions in addition to the blade force.

Cut 

1.

2.

RIP & Print

1.

2.

Print Count

1.

2.

Sheet Cut / Scissor Cut

  1. Press [FUNCTION].
  2. Press [▼] several times to display the screen shown below.
  3. Press [ENTER].

VersaWorks Advanced Function

TILE

1.

2.

Clipping

1.

2.

Mark

1.

2.

Head Height

1.

2.

General

1.

2.

Maintenance

Roland TrueVIS VG2 and SG2 series – Manual Cleaning Procedure

Roland TrueVIS VG and SG series – Manual Cleaning Procedure

©2021  Spyder3D® LLC.

CONTACT US

We're not around right now. But you can send us an email and we'll get back to you, asap.

Sending

Log in with your credentials

Forgot your details?